Samsung Galaxy A32 4G was finally launched in India which includes a 90Hz display and features quad rear cameras. The Samsung Galaxy A32 also includes Dolby Atmos support as well as offers a waterdrop-style display notch. The camera on the device sports a quad rear camera setup that houses a 64 MP primary sensor, 8 MP secondary sensor with a 123-degree ultra-wide-angle lens, 5 MP macro shooter, and a 5 MP depth sensor.

In this tutorial, we will guide you on how to install the Samsung SM-A325M (Galaxy A32 4G) Binary 1 U1 flash file using the Samsung flash tool (also known as the ODIN flash tool). On this page, you will find the official stock firmware file for the Samsung Galaxy A32 4G SM-A325M, drivers, and flash tool.

Also Read

Will Samsung Galaxy A32 Get Android 12 (One UI 4.0) Update?

Samsung A32 SM-A325F FRP Bypass | Use EFT, CM2, UMT

Will Samsung Galaxy A32 Get Android 13 (One UI 5.0) Update?

Fix: Samsung A32 and A52 No Signal or Network Problem

Fix: Samsung A32 Not Receiving Calls and Text Messages

By flashing the Stock ROM file, you can always fix the device software issue such as boot loop, lag, soft brick or hard brick, remove pattern lock, FRP lock, and many more.

Samsung Galaxy A32 4G SM-A325M U1 Firmware Flash Files:

Steps to Install Firmware File on Samsung A32 4G SM-A325M

Before we get straight to the steps to Install Stock Firmware on your Samsung Galaxy A32 4G, let us take a look at the pre-requirements first.

Pre-Requirements: 

  • This Guide is for Samsung Galaxy A32 4G SM-A325M
  • You need a Windows PC/Laptop and a USB cable to flash the firmware.
  • Charge your device with a minimum of 50% battery backup.
  • You have to download the latest Samsung USB Drivers and install them on your PC.
  • Make sure that you have ODIN Software installed on your PC.
  • Take a backup of your device (No Root) before doing anything.

Now, let’s take a look at Steps to flash Stock ROM on Samsung Galaxy A32 4G.

Installation Guide

  • Download the Samsung SM-A325M firmware flash file
  • Extract the contents of the firmware flash file zip.
  • Launch the ODIN application
  • Load the firmware files in their appropriate section
  • Once you have loaded, now connect your phone to the computer (make sure to boot your device into download mode)
  • Notice that the CO port will light up on Odin once you connect your phone.
  • Click the Start button to install the firmware on your Samsung device.
  • That’s it! You will see a PASS message once the installation is complete.

Check out our full-depth video guide as well.

Disclaimer:

We hope that this guide will be helpful to you. If in case, you’re facing any issues, feel free to ask in the comments below.