Samsung Galaxy S22 Ultra 5G was the latest S series with S Pen built into the phone’s body. The device features a  6.8-inch Edge QHD+ Dynamic AMOLED 2X display with a 120Hz adaptive refresh rate. It is powered by Qualcomm Snapdragon 8 Gen 1 coupled with 12GB RAM.

This tutorial will guide you on how to install the Samsung SM-S908B (Galaxy S22 Ultra) Binary 1 U1 flash file using the Samsung flash tool (also known as the ODIN flash tool). On this page, you will find the official stock firmware file for the Samsung Galaxy S22 Ultra SM-S908B, drivers, and flash tool.

By flashing the Stock ROM file, you can always fix the device software issues such as boot loop, lag, soft brick or hard brick, remove pattern lock, FRP lock, etc.

Also Read

Fix: Samsung Galaxy S22 Ultra Not Turning On

Fix Samsung Galaxy S22 Ultra WiFi Issue | Not Connecting, Slow or No Internet

Fix: Samsung Galaxy S22 Ultra Keeps Crashing

Fix Samsung Galaxy S22 Ultra Won’t Recognize SIM Card Issue

Will Samsung Galaxy S22 Ultra Get Android 13 (One UI 5.0) Update?

Fix: Samsung Galaxy S22, S22 Plus, and S22 Ultra GPS Problem or Not Accurate

How to Install Custom ROM on Samsung Galaxy S22 Ultra

Fix: Samsung S22 Ultra Not Recording Video, Lagging, or Bad Quality

Samsung Galaxy S22 Ultra SM-S908B U1 Firmware Flash Files:

Steps to Install Firmware File on Samsung Tab A7 Lite SM-S908B

Before we get straight to the steps to Install Stock Firmware on your Samsung Galaxy S22 Ultra, let us take a look at the pre-requirements first.

Pre-Requirements: 

  • This Guide is for Samsung Galaxy S22 Ultra SM-S908B
  • You need a Windows PC/Laptop and a USB cable to flash the firmware.
  • Charge your device with a minimum of 50% battery backup.
  • You have to download the latest Samsung USB Drivers and install them on your PC.
  • Make sure that you have ODIN Software installed on your PC.
  • Take a backup of your device (No Root) before doing anything.

Now, let’s take a look at Steps to flash Stock ROM on Samsung Galaxy S22 Ultra.

Installation Guide

  • Download the Samsung SM-S908B firmware flash file
  • Extract the contents of the firmware flash file zip.
  • Launch the ODIN application
  • Load the firmware files in their appropriate section
  • Once you have loaded, now connect your phone to the computer (make sure to boot your device into download mode)
  • Notice that the CO port will light up on Odin once you connect your phone.
  • Click the Start button to install the firmware on your Samsung device.
  • That’s it! You will see a PASS message once the installation is complete.

Check out our full-depth video guide as well.

Samsung Galaxy S22 Ultra Unlock Bootloader Guide | How to

Samsung Galaxy S22 Ultra Battery Draining Fast, How to Improve Battery Life?

Advertisement

How to Fix If Volume Button Not Working on Samsung Galaxy S22 Ultra

Disclaimer:

We hope that this guide will be helpful to you. If in case, you’re facing any issues, feel free to ask in the comments below.

How to Fix Samsung S22 Ultra No Signal or Network Problem